C.H.I. Commercial Aluminum Full-View: 3295

3295 Aluminum Full-View


Section Construction

  • 2" Thick Sections with Rail & Stile Construction assembled with through bolts at each vertical stile location
  • Glass or Aluminum Panels (Insulated or ¼” tempered glass available in some sizes)


  • Max Width - 20'2" (contact customer service for larger sizes)

Colors / Appearance

  • Clear Anodized Aluminum, White
  • Stock RAL powder-coat option in 188 colors

Various accessories and options available.

Clean modern look is combined with flexibility, durability and quality.

The model 3295 aluminum garage door draws a substantial presence, even with its simplicity. Clean lines and sleek glass door panels achieve the streamlined look that transforms your home over and over again.



  • Section joints are tongue-and-groove for a superior weatherseal
  • Wide bottom rails, top rails, and end stiles create an extra-strong frame for the door
  • Insulated and 1/4" tempered glass is available in some sizes
  • Aluminum panels can be substituted for glass panels
  • Glass or aluminum garage door panels can be easily replaced by removing an inside retainer
  • Bottom "U" type astragal is a standard feature


  • 3/8" Insulation available with aluminum panel option

Colors / Finish:


Track Configuration:

  • Tracks are 2' or 3', as specified
  • 12" radius, 15" radius
  • Normal Headroom, Low Headroom, Vertical Lift, High Lift, Incline
  • 20" & 32" radius (2" track & up to 10' high doors only)
Normal Headroom / Standard Lift View PDF
Low Headroom: Front Mount View PDF
Low Headroom: Rear Mount View PDF
Vertical Lift View PDF
High Lift View PDF
Incline View PDF

Mounting Options:

  • Bracket Mount (leg out), Clip Angle Track, Continuous Angle Track
Bracket Mount View PDF
Clip Angle Track View PDF
Continuous Angle Track View PDF
Reverse Angle Mount View PDF

Track Gauge:

  • 2" Tracks - up to 8'-0" high = 17 gauge roll-formed galvanized steel
  • 2" Tracks - 8'-0" 10'-0" = 16 gauge
  • 2" Tracks - over 10'-0" = 14 gauge
  • 3" Tracks - 12 gauge



  • 11-gauge or 14-gauge hinges, as specified


  • 2" or 3" long-stem or short-stem steel ball bearings rollers


  • Top fixtures (min. 12 gauge)
  • Bottom fixtures (min. 13 gauge)

Single or Double Edge Endstiles:


Counterbalance System (Springs)

  • Oil tempered torsion springs are mounted on a cross-header shaft supported by galvanized steel ball breaking end plates and center bracket(s)
  • Springs are calculated for exact door weight, size and trajectory in accordance with ANSI 102 standards for a minimum of 10,000 cycles

    NOTE: May be specified for higher cycles when available

  • Counterbalance is transferred through galvanized aircraft quality cables secured to bottom of the door
Torsion/Spring Assembly with Four Spring Layout, Standard Headroom


  • Manual Operation
  • Motor Operation: Trolley or Jackshaft
  • Chain Hoist Operation
Jackshaft Operation
Troley Operation

Glass Options

Optional Window Designs:

  • Optional field glazing
  • 1/8" (DSB or tempered) plain, tinted or frosted
  • 1/8" polycarbonate
  • 1/4" (tempered) plain, tinted or frosted
  • 1/4" clear or white laminated
  • 1/2" (insulated or tempered insulated) plain, tinted, frosted or low E
  • Custom glass options available. Contact factory.